Contact support

Terminals & Devices

SY745 - Create and Clear Memory Crash Procedures

1. Clear Memory Crash

  1. Press 6 times on the 0 key. An asterisk appears for each time that this key is pressed.
  2. Press on the Enter key once.
  3. Press 3 times on the line up key. (Next to the display on right hand side)
  4. Press twice on the line down key. (Next to the display on right hand side)
  5. Press 3 times on the line up key. (Next to the display on right hand side) The message "CLEAR MEMORY?" will appear on the display.
  6. Press once on the line down key. (Next to the display on right hand side)
  7. The message MEMORY CLEARED will appear on the display.
  8. You receive a NO PROG display.
  9. Program the terminal using Software.

2. Create Memory Crash

  1. Unplug the terminal and make sure that it is off. The back-up battery automatically supplies power for approx. 15 seconds.
  2. Unscrew and remove the front panel.
  3. Remove the JP4 jumper from the 1-2 position to 2-3 position.
  4. Reposition JP4 to (1-2).
  5. Plug the terminal back into a power source and make sure that MEM CRASH reappears in the terminal display.