Contact support

Biometrics & Enrolment

SY910: Clock Not Recognising Faces

If an SY910 stops recognising someone, or doesn't recognise anyone, work through these checks.

Nobody is recognised

  • Check the clock is online (network icon at the top left). If not, see SY910: Network Requirements and Offline Clocks.
  • Check the employees' Synergy Face Employee Auth. Mode in Personnel, on the Additional Settings tab. If it is Card and Face, the clock waits for a card before it looks at the face. For face only, it must be Face.
  • Check the lighting. A bright light or window behind the person, in the clock's view, stops it reading faces. The clock is for indoor use, out of direct sunlight.

One person isn't recognised

  1. Check they are active in Synergy Workforce and allowed to use this clock (their Device Allocation tab in Personnel, and their department's Devices tab).
  2. Sync them to the clock. See How to sync an employee to SY910.
  3. If that doesn't help, delete their face template and enrol them again. See How to Delete an Employee's Face Template and Employee Face Enrolment Guide.

Tips for reliable recognition

  • Stand 9 to 25 inches (about 25 to 65 cm) from the screen, face centred between the two cameras.
  • Remove sunglasses. If someone wears glasses or a hat, have them take it off halfway through enrolment.
  • Use a normal facial expression.

If the clock's screen or keypad is damaged, or the camera doesn't respond at all after a power cycle, it needs a repair. Contact Synel Support.